Daikin MC707VM-S, Operation Manual

Page: 6 / 19

5
/ English
Preparation Before Operation
„ „ „ „ Remote controller setup
1. Remote controller
preparations
• Battery is already set in the remote
controller but the remote controller
cannot be used as is without first
preparing it.
Use the remote controller after
pulling out the clear sheet from the
battery cover.
2. Remote controller storage
• When the remote controller is not
being used, you can store it in the
remote controller storage slot.
3. Using the remote controller
• Point the transmitter of the remote
controller towards the receiver of
the main unit.
If an obstruction to the signal, such
as a curtain, exists, the remote
controller will not operate.
• The distance from which the
remote controller can transmit is
approximately 6m.
4. Battery replacement
1. Open the cover on the rear of the
remote controller towards the
arrow.
2. Replace the battery with CR2025
battery.
(Be sure to set the battery with the
+ side of the cover as shown in
the figure.)
3. Close the cover to its original
position.
NOTE
•
Store the batteries where babies and children cannot reach them.
If, by chance, a battery is swallowed, be sure to contact a doctor
immediately.
•
When discarding batteries, cover the terminals of the batteries with
tape.
If mixed with other metal or batteries, heat, explosion or combustion
may occur.
•
Bring the batteries to a nearby electronics store, watch store or
camera store to recycle them.
ATTENTION
Battery
•
The included coin type battery is prepared for initial use.
They will be consumed within 1 year from the manufacturing date of
the air purifier.
•
A replacement target is approximately 1 year but if the reception
becomes difficult, replace the batteries with new coin type battery
CR2025.
•
Coin type battery close to the “recommended usage period” may
need to be replaced soon.
•
In order to prevent malfunctions or injuries due to leaking or
explosions, be sure to remove the coin type battery when the unit
will not be used for a long period of time.
Remote controller
•
Do not drop or place the remote controller in water.
(Damage may occur.)
•
Do not press the remote controller buttons with sharp objects.
(Damage may occur.)
•
The signals may not be received well of electronic lighting style
fluorescent lamps (such as inverter fluorescent lamps) are in the
same room. For these cases, discuss with the dealer.
•
If other electrical device operate by the remote controller, either
separate them from the remote controller or discuss with the dealer.
„
„ „
„ Attaching the pleated filter
WARNING
Set the filter while the power supply plug is not plugged in.
CAUTION
•
The unit must be operated with a pre-filter.
If they are not set and the unit is operated, malfunctions may occur.
1. Remove the front panel.
• Place your fingers in the indentations on the bottom of the unit
and pull forward, holding on to the bottom of the panel.
CAUTION
•
Do this before plugging the unit into a power supply.
•
Always install the pleated filter before running the unit.
2. Remove the shock-absorbing material and then remove
the plasma ionizer.
1) Remove the shock-absorbing material.
2) Holding the handle, lift towards yourself and remove from the top
2 hooks.
Receiver
Front panel
Shock-absorbing
material (cardboard)
Plasma ionizer
Hooks
(one left and one right)
01_EN_3P167171-1A.fm Page 5 Tuesday, October 18, 2005 4:14 PM