Daikin M08B128, Installation Manual

Page: 3 / 10

Indoor Unit Installation Drawings
Intelligent-eye Sensor
1) Do not hit or violently push the intelligent-eye sensor. This can lead to damage and malfunction.
2) Do not place large objects near the sensor. Also keep heating units or humidifiers outside the
sensor’s detection area.
CAUTION
1) Insert the tool into the groove of the
front grille fixture.
How to remove front grille fixture
2) Turn the tool 90˚ in the direction of
the arrow.
3) Take out the front grille fixture.
1-3/16” (30mm) or more
from ceiling
Wrap the insulation pipe with
the finishing tape from bottom
to top.
Cut thermal insulation
pipe to an appropriate
length and wrap it with
tape, making sure that no
gap is left in the insulation
pipe’s cut line.
Caulk
pipe hole
gap
with putty.
C Titanium Apatite Photocatalytic
Air-Purifying Filter (3)
How to attach the indoor unit.
Hook the claws of the bottom frame
to the mounting plate.
If the claws are difficult to hook,
remove the front grille.
How to remove the indoor unit.
Push up the marked area (at the
lower part of the front grille) to
release the claws. If it is difficult to
release, remove the front grille.
Opening service lid
Service lid is opening/closing type.
Opening method
1) Remove the service lid screws.
2) Pull out the service lid diagonally
down in the direction of the arrow.
3) Pull down.
Air filters
Front grille
A Mounting
plate
Clip
Bottom frame
Mark (rear side)
A Mounting plate
Mounting plate fixing
screws 3/16” × 1”L (M4 × 25L) (9)
B
The mounting plate
should be installed on a
wall which can support the
weight of the indoor unit.
Intelligent-eye sensor
1-15/16” (50mm) or
more from walls
(on both sides)
Front panel
3/16” × 5/8”L
(M4 × 16L)
3/16” × 5/8”L
(M4 × 16L)
3/16” × 5/8”L
(M4 × 16L)
Service lid Front grille fixture
Wireless
remote
controller D
E
Remote
controller holder
Before screwing the remote
controller holder to the wall,
make sure that control
signals are properly
received by indoor unit.
Fixing screws for
remote controller holder
1/8” × 13/16”L
(M3 × 20L) (2) F
Titanium Apatite Photocatalytic
Air-Purifying Filter
Filter frame
Air filter
Tab
Bottom of indoor unit
Front grille fixture
Screw cover M