0-UC 13-FEB 18-2
Page 9
1.5
General
Upon receive of the products,
1. Please ensure:
• The pipework should show no signs of damage
• The fan/ fan motor terminals box is not cracked or showing signs of obvious damage
• The electrical screw terminals in control panels and motor mountings should be checked for security.
2. Product are only suitable for fix installation.
Product contains 4 bar±1bar holding charge (N2) when despatched from factory, the holding gas should
be safely released through the schrader valve which integrated on the suction gas inlet header.
3. If the holding charge is not present, please do not use the product and contact the sales representative
immediately. (Manufacturer’s warranty is void for damage caused by incorrect application or unit mis-
handling)
2
Health and Safety
2.1
General information
Before Installation
•
Ensure the units received are the correct models for the intended application.
•
Ensure the refrigerant, voltage and MWP are all suitable for the proposed application.
•
Check there is no damage to the units. Any damage should be advised to the supplier immediately.
•
Check that the proposed equipment locations are suitable and provide adequate support for the weight
of the units.
Important Note:
Only a qualified refrigeration engineer, who is familiar with refrigeration systems and components
including all controls, should perform the installation and start-up of the system. To avoid potential
injury, use care when working around coil surfaces or sharp edges of metal cabinets. All piping and
electrical wiring should be installed in accordance with all applicable codes, ordinances and local by-
laws.
