Daikin KRCS01-8B, Installation Manual

Page: 4 / 10

English 2
Mounting
Remove the cover of the sensor box.
2
1
1. Insert a fl at blade screw driver
(about 6mm width) into the sensor
box concave part (2 locations).
2. Remove the cover pushing up the
nail to the cover of the sensor box.
Cautions:
■ Do not push the nail powerfully
with a narrow fl at blade screw driver,
because you may break off the nail.
When mounting on the wall
a
b
c
d
e
f
g
a Mounting screw
b Thermal insulation material
c Knockout hole for cable
d Sensor box
e Air hole
f Released paper
g Sensor box cover
2-M4
32
42
• Break open the knockout hole in the sensor box with a nipper or a similar
tool. Pass the extension wires through the hole and fasten the wires to the
terminals with screws.
• To avoid tensile force on the terminals, pass the attached clamp through
the holes shown in the following fi gure and tighten the extension cable with
the attached clamp at the sheathed part. (The knot must come to the box
inside.)