E
D
Installation Procedure (5)
1) Drill a ø5/32” (ø4mm) hole in the partition plate for installing the snap band. (1 location)
2) Insert the snap band into the drilled hole.
3) Remove the anti-bypass plate and cut it off, and then affix the F sealing material (square) to protect
the harness.
4) Install the cut anti-bypass plate to the original position.
5) Insert the snap band into the hole in the electrical wiring box to fix it.
• Any of the holes can be used.
6) Fix the harness on the electrical wiring box with the D binding band.
• Cut the tip of binding band.
KEH041A44
F
Hole:
Drill a hole in alignment with the
actual component and at a
position where the harness will
not become loose or too tense.
D Binding band
Snap band
View
E
View
D
Anti-bypass plate:
Remove it and cut it off as
shown in the illustration.
Any of the holes can be used.
F Sealing material
(square)
KEH041A49
Snap band
D
