Installation and Operation
EDUS39-800-F9
36
FXZQ-M
3-1
Precautions
Improper tightening of the screws (see figure 7) may cause
air to leak into the unit and air to escape between the ceil-
ing and the decoration panel (1), resulting in contamination
(2) and dew formation (3).
If there is a gap remaining between the ceiling and the dec-
oration panel after tightening the screws, re-adjust the
indoor unit body height.
3 Wiring of the decoration panel (See figure 8)
1
Screws (2)
2
Switch box
3
Swing flap motor lead wire
4
Hang the swing flap motor lead wire on this tab
5
Connector of the decoration panel swing flap
motor
6
Connector of the indoor unit
7
Clamp
Pass the swing flap motor lead wire through the
clamp as shown. After connection, store the con-
nector inside the switch box.
1 Remove the switch box cover after making sure that
the power to the unit is off.
2 Connect the connectors of the swing flap motor lead
wire.
3 Put the switch box cover back in place and fix it with the
2 screws again.
NOTE
If the connectors are not connected properly, the swing
flap will not work.
Make sure that the swing flap motor lead wire is not
caught between the indoor unit and the decoration
panel.
4.
INSTALLATION OF THE SUCTION
GRILLE
Install the suction grille by reversing the procedure shown in
"Preparing the decoration panel for installation" on page 1.
The suction grille may be installed in 4 directions by simply
turning it 90 degrees.
Change the direction when adjusting the direction of the
suction grille of multiple units or to comply with the
demands of the customer.
NOTE
Be careful not to get the swing flap motor lead wire get caught
when installing the suction grille.
Summary of Contents for FXZQ-M Series
Page 1: ...EDUS 39 800 F9_a AMERICAS FXZQ M 4 Way Ceiling Mounted Cassette Unit 2 2 ...
Page 3: ...External Appearance EDUS39 800 F9_a 2 FXZQ M 1 External Appearance FXZQ07 18M ...
Page 7: ...Dimensions EDUS39 800 F9_a 6 FXZQ M 3TW30724 3 FXZQ07 18M7VJU BYFQ60B8W1 BYFQ60B8W1U ...