17
English
〈
When using a wireless remote controller
〉
A wireless remote controller address needs to be set when
•
using a wireless remote controller. See the installation
manual included with the wireless remote controller for
details on how to make the settings.
Perform a test run according to the outdoor unit’s installa-
tion manual.
The operation lamp of the remote controller will fl ash when a
•
malfunction occurs. Check the malfunction code on the
liquid crystal display to identify the point of trouble. An
explanation of malfunction codes and the corresponding
trouble is provided in “CAUTION FOR SERVICING” of the
outdoor unit.
If the display shows any of the following, there is a possibility
that the wiring was done incorrectly or that the power is not
on, so check again.
Remote control display
Content
“
” display
There is a short circuit at the FORCED
•
OFF terminals (T¹, T²).
“
U3
” display
The test-run has not been performed.
•
“
U4
” display
“
UH
” display
The power on the outdoor unit is off.
•
The outdoor unit has not been wired for
•
power supply.
Wiring is incorrect for the transmission
•
wiring and / or FORCED OFF wiring.
The transmission wiring is cut.
•
“
UF
” display
Reversed transmission wiring
•
No display
The power on the indoor unit is off.
•
The indoor unit has not been wired for
•
power supply.
Wiring is incorrect for the remote control-
•
ler wiring, the transmission wiring and /
or the FORCED OFF wiring.
The remote controller wiring is cut.
•
CAUTION
Always stop the test run using the remote controller to stop
•
operation.
Summary of Contents for FXTQ12PAVJU
Page 19: ...3P250363 2B EM09A034A 1011 FS...