background image

 

FXLQ20~6 FXNQ20~63P2VEB
VRV System air conditioners
4P323720-1 – 2012.06

Installation and operation manual

2

Accessories

Check if the following accessories are included with your unit.

Optional accessories

There are two types of remote controllers: wired and wireless.

Select a remote controller according to customer request and
install in an appropriate place.

Refer to catalogues and technical literature for selecting a
suitable remote controller.

For the following items, take special care during 
construction and check after installation is finished

Notes to the installer

Read this manual carefully to ensure correct installation. Be sure
to instruct the customer how to properly operate the system and
show him/her the enclosed operation manual.

Explain to the customer what system is installed on the site. Be
sure to fill out the appropriate installation specifications in the
chapter "What to do before operation" of the outdoor unit
operation manual.

This unit can be installed on the floor or be mounted to a wall.

Important information regarding the 
refrigerant used

This product contains fluorinated greenhouse gases covered by the
Kyoto Protocol.

Refrigerant type:

R410A

GWP

(1)

 value:

1975

(1)

 GWP = global warming potential

Periodical inspections for refrigerant leaks may be required
depending on European or local legislation. Please contact your local
dealer for more information.

Selecting installation site

1

Select an installation site where the following conditions are
fulfilled and that meets your customer's approval.
- The installation location is frost-free.
- Where optimum air distribution can be ensured.
- Where nothing blocks air passage.
- Where condensate water can be properly drained.
- Where the floor or wall is strong enough to bear the indoor 

unit weight.

- Where sufficient clearance for maintenance and service can 

be ensured.

- Where piping between indoor and outdoor units is possible 

within the allowable limit. (Refer to the installation manual of 
the outdoor unit.)

- This is a class A product. In a domestic environment this 

product may cause radio interference in which case the user 
may be required to take adequate measures.

- Keep indoor unit, outdoor unit, power supply wiring and 

transmission wiring at least 1 meter away from televisions 
and radios. This is to prevent image interference and noise in 
those electrical appliances. (Noise may be generated 
depending on the conditions under which the electric wave is 
generated, even if 1 meter is kept.)

- When installing the wireless remote controller kit, the 

communication distance between wireless remote controller 
and indoor unit might be shorter if there are fluorescent lights 
who are electrically started in the room. The indoor unit must 
be installed as far as possible away from fluorescent lights.

- Do not place objects that are susceptible to moisture directly 

beneath the indoor or outdoor units. Under certain conditions, 
condensation on the main unit or refrigerant pipes, air filter 
dirt or drain blockage may cause dripping, resulting in fouling 
or failure of the object concerned.

1

Metal clamp

6

Insulation for liquid pipe

2

Drain hose

7

Clamp

3

Leveling screw

8

Installation and operation 
manual

4

Sealing pad

5

Insulation for gas pipe

Tick 

 

when 

checked

Is the indoor unit fixed firmly?

The unit may drop, vibrate or make noise.

Is the gas leak test finished?

It may result in insufficient cooling or heating.

Is the unit fully insulated and checked for air leaks?

Condensate water may drip.

Does drainage flow smoothly?

Condensate water may drip.

Does the power supply voltage correspond to that shown on the 
name plate?

The unit may malfunction or components may burn out.

Are wiring and piping correct?

The unit may malfunction or components may burn out.

Is the unit safely grounded?

Dangerous at electric leakage.

Is the wiring size according to specifications?

The unit may malfunction or components may burn out.

Is nothing blocking the air outlet or inlet of either the indoor or 
outdoor units?

It may result in insufficient cooling or heating.

Are refrigerant piping length and additional refrigerant charge 
noted down?

The refrigerant charge in the system might not be clear.

1x

1x

4x

1x

1x

1x

1

2

3

5

6

1x

8

8x

7

4

Summary of Contents for FXLQ20P2VEB

















Reviews: