![background image](http://html1.mh-extra.com/html/daikin/fxaq07pvju/fxaq07pvju_operation-manual_2459649005.webp)
English
4
2. Pullout the air filter.
Push up the tab in the center of the air filter slightly then pull
out in a downward direction.
3. Clean the air filter.
Use vacuum cleaner
A)
or wash the air filter with water
B)
.
A)
Using a vacuum cleaner
B)
Washing with water
When the air filter is very dirty,
use soft brush and neutral deter-
gent
Remove water and dry in the shade.
NOTE
•
Do not wash the air filter with hot water of more than 120°F,
as doing so may result in discoloration and/or deformation.
•
Do not expose it to fire, as doing so may result in burning.
4. Attach the air filter.
Once cleaning is done be sure to replace the air filter as it
was.
5. Shut the front panel.
Refer to item No.1.
6. Press the FILTER SIGN RESET button on the remote
controller.
The “TIME TO CLEAN FILTER” display vanishes.
HOW TO CLEAN THE AIR OUTLET AND EXTERIOR
•
Clean with soft cloth.
•
When it is difficult to remove stains, use water or neutral
detergent.
NOTE
•
Do not use gasoline, benzene, thinner, polishing powder, liq-
uid insecticide. It may cause discoloring or warping.
•
Do not use water or air of 120°F or higher for cleaning air filters.
•
When the flap is extremely contaminated, remove it as below
and clean or exchange it. (Flap for exchange is optional.)
HOW TO CLEAN THE FRONT PANEL
You can remove the front panel to clean it.
NOTE
•
Hold the front panel firmly so that it does not fall.
•
Do not use gasoline, benzene, thinner, polishing powder, liq-
uid insecticide. It may cause discoloring or warping.
•
Do not let the indoor unit get wet. It may cause an electric
shock or a fire.
•
Do not scrub firmly when washing the blade with water.
The surface sealing may peel off.
•
Do not use water or air of 120°F or higher for cleaning air fil-
ters and outside panels.
•
Make sure the front panel is solidly in place.
1. Open the front panel.
Place your fingers on the panel protrusions on the left and
right sides of the main unit and open until the panel stops.
(Follow the same procedure for closing.)
2. Remove the front panel.
Push the axes on either side of the front panel towards the
center of the main unit and remove.
(You can also remove it by sliding the front panel either to
the left or right and pulling it forward.)
3. Clean the front panel.
•
Wipe gently with a soft wet cloth.
•
Only use neutral cleaning agents.
•
After washing off, wipe off any excess water and dry in a
shaded location.
• When very grimy
Directly apply the type of detergent used for cleaning
ventilation fans or ovens, wait 10 minutes, and then rinse
with water.
NOTE
•
Do not wash the air conditioner with hot water of more than
120°F. Doing so may result in discoloration or deformation.
4. Attach the front panel.
Set the keys of the front panel into the slots and push them
in all the way.
Close the front panel slowly in this state.
01_EN_3PN07520-6E.fm Page 4 Thursday, December 8, 2011 5:11 PM