3
English
HOW TO ADJUST THE HORIZONTAL FAN
DIRECTION ANGLE
Hold the tabs on edge louvers (horizontal air outlet direction
adjustment flaps) down slightly and adjust left and right to match
the room conditions or your preference.
Stop the vertical flaps at a position where you can hold the tabs
and adjust the louver left and right.
MAINTENANCE
(FOR SERVICE PERSONNEL)
NOTE
•
Do not remove the air filter except when cleaning.
This may cause breakage.
HOW TO CLEAN THE AIR FILTER
Clean the air filter when the display shows “TIME TO CLEAN
FILTER”.
•
It will display that it will operate for a set amount of time.
•
Increase the frequency of cleaning if the unit is installed in a
room where the air is extremely contaminated.
•
If the dirt becomes impossible to clean, change the air filter
(Air filter for exchange is optional)
1. Open the front panel.
Place your fingers on the panel protrusions on the left and
right sides of the main unit and open until the panel stops.
(Follow the same procedure for closing.)
Drain pipe
Name plate
Air inlet
(front and top of main unit)
Air filter
(Inside intake vent)
Refrigerant pipe
Transmission wiring
Remote controller
Vertical flaps
(vertical air outlet direction adjustment flaps)
Louver
(horizontal air outlet direction
adjustment flaps)
Air outlet
Ground wire
Conducts electricity from the
unit into the ground to prevent
electric shock.
(Indoor unit model name)
Packaging materials
If any packaging materials are
included, please remove
before operating.
Power supply wiring
01_EN_3PN07520-6E.fm Page 3 Thursday, December 8, 2011 5:11 PM
