8
Preparation before Operation
To set the batteries
Slide the front cover to take it off.
1.
Set 2 dry batteries AAA.LR03 (alkaline).
2.
Set the front cover as before.
3.
To
fi
x the remote controller holder on the wall
Choose a place from where the signals reach
1.
the unit.
Fix the holder to a wall, a pillar, etc. with the
2.
screws supplied with the holder.
Place the remote controller in the remote
3.
controller holder.
Celsius/Fahrenheit display switch
The Celsius or Fahrenheit display is selectable with the following buttons.
•
Press
and
buttons simultaneously
for 5 seconds.
The temperature will be displayed in Fahrenheit if it is presently displayed in Celsius, and
•
vice versa.
2
3
1
Position and
correctly!
+
–
Remote controller
holder
Set.
Pull.
ATTENTION
About batteries
When replacing the batteries, use batteries of the same type, and replace the 2 old batteries together.
•
When the system is not used for a long time, take the batteries out.
•
The batteries will last for approximately 1 year. If the remote controller display begins to fade and the degradation of reception performance occurs
•
within a year, however, replace both 2 batteries with new, size AAA.LR03 (alkaline).
The attached batteries are provided for the initial use of the system.
•
The usable period of the batteries may be short depending on the manufactured date of the air conditioner.
About remote controller
Never expose the remote controller to direct sunlight.
•
Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with soft cloth.
•
Signal communication may be disabled if an electronic-starter-type
fl
uorescent lamp (such as inverter-type lamps) is in the room. Consult the shop
•
if that is the case.
If the remote controller signals happen to operate another appliance, move that appliance to somewhere else, or consult the service shop.
•
Celsius/Fahrenheit display change function of remote controller
The set temperature may increase when the display is changed to Celsius from Fahrenheit, because a fraction of 0.5°C is rounded up.
•
Example: A set temperature of 64°F (equivalent to 18.5°C) will be converted into 19°C.
•
When the display is changed to Fahrenheit again, the set temperature will be converted into 66°F (equivalent to 19°C) instead of the
original set temperature (64°F) but a set temperature of 66°F (equivalent to 19°C) will be converted into 19°C with no temperature change.
A reception sound will go off for the transmission of set temperature to the indoor unit at the time of setting the Celsius/Fahrenheit display change function.
•
01_EN_3P232717-1C.indd 8
01_EN_3P232717-1C.indd 8
12/22/2008 2:51:31 PM
12/22/2008 2:51:31 PM
