■
English
18
Attaching and removing the front panel
1. Open the front panel.
•
Placing a finger on the panel tab on either side of the front panel.
2. Remove the front panel.
•
Spread out the shaft hole and remove
the rotating shaft. (Both left and right
sides.)
3. Attach the front panel.
•
Place the revolving axes on either side of the front panel into
the holes and slowly close.
(Press either side of the front panel.)
Attaching and removing the upper panel
1. Remove the front panel and pull
out the air filter.
(page 19.)
2. Remove the upper panel.
1) Hold the 2 tabs on either side of the upper
panel and pull forward to remove.
2) Remove the tab in the center and lift.
3. Attach the upper panel.
•
Insert the 3 tabs on back of the upper panel
and then push it down.
•
Push the upper panel down until it clicks.
Cleaning for each case
•
Wipe it with a soft cloth soaked in water. (Only neutral detergent may be used.)
•
In case of washing the front panel with water, dry it with cloth, dry it up in the shade after washing.
CAUTION
•
Only open the front panel after turning the unit off.
Opening the panel during operation may cause the panel to fall off.
•
When removing or attaching the front panel, use a robust and stable stool and watch your steps carefully.
•
When removing or attaching the front panel, support the front panel securely with hand to prevent it from falling.
•
For cleaning, do not use hot water above 40°C, benzine, gasoline, thinner, nor other volatile oils, polishing compound, scrubbing brushes, nor other hand stuff.
•
After cleaning, make sure that the front panel is securely fixed.
•
Wipe the front panel with a soft cloth. Wiping with a hard cloth may scratch it.
CAUTION
Front panel
Rotating
shaft
Rotating
shaft
Shaft
hole
Shaft
hole
Shaft
hole
Rotating
shaft
Tabs (One on each side)
Tab (Center)
Tabs (3 locations)
01_EN_3P190650-1D.fm Page 18 Tuesday, March 6, 2007 6:26 PM
