Ŷ
To adjiust the louvers (vertical blades)
Adjusting the Airflow Direction
Ŷ
To start auto swing
Upper and lower air
You can adjust the airflow direction to increase your comfort.
À
ow direction
Press
.
• “
”
appears on the LCD.
The flaps (horizontal blades) will begin to swing.
•
This function is effective while flaps are in auto swing mode.
Ŷ
To set the
À
aps at desired position
•
Press
when the
À
aps the desired position.
• “
”
disappears from
the LCD.
CAUTION
• Always use a remote controller to adjust the angles of the flaps. If you attempt to move the flaps forc bly by hand when they are swinging,
the mechanism
may be bro
k
en.
Hold the knob and move the louvers.
(You will find a knob on the left-side and the right-side blades.)
When the unit is installed in the corner of a room,
the direction of the louvers should be facing away
from the wall.
If they face the wall, the wall will block off the wind,
causing the cooling (or heating) efficiency to drop.
•
N
Knobs
11
Movable range of the flap
COOL / DRY
HEAT
FAN ONLY
NOTE
Ŷ
Notes on airflow direction setting
•
The movable range of the flaps varies according to the operation mode.
At smaller airflow rates, the cooling (heating) effect is also smaller.
Ŷ
Note on air
À
ow rate setting
•
There is a knob in 2 places.
•
• The flap will stop at the upper position when the airflow rate is changed to low during the
up and down swing setting.
