Daikin FT50GAVE, Operation Manual

Page: 10 / 18

9
DRY • COOL • FAN
Operation
The air conditioner operates with the settings of
your choice. From the next time on, the air
conditioner will operate with the same settings.
1
Press MODE and select a mode.
●
Each pressing of the button advances
the mode setting in sequence.
2
Press
ON/OFF
.
Then OPERATION
lamp lights up.
■
To stop:
Press
ON/OFF
once again.
Then OPERATION lamp goes off.
■
To change the temperature setting:
■
To change the air flow rate setting:
Press
FAN
.
●
At smaller air flow rates, cooling or
heating effect is also smaller.
Display
DRY or FAN mode
The temperature
setting is not
variable.
COOL mode
Press
to raise / lower the temperature.
Set to the
temperature you like.
TEMP
DRY mode
The air flow rate
setting is not
variable.
COOL or FAN mode
Five levels of air flow rate setting
from “ ” to “ ” plus “ ” are
available.
Display
Adjusting the Air
Flow Direction
ATTENTION
●
Be careful when adjusting the louvre. Inside
the air outlet, a fan is rotating at a high speed.
ATTENTION
●
Always use a remote controller to adjust
the flap angle. If you attempt to move it
forcibly with hand when it is swinging, the
mechanism may be broken.
You can adjust the air flow direction to increase
your comfort.
Adjusting the horizontal
blade (flap)
Press SWING .
●
Every time the button is pressed, “ ”
appears or disappears.
....... The flap automatically
swings up and down.
....... To stop the flap at an angle
you like, press
SWING
.
Notes on flap angles
●
When
SWING
is selected, the
flap swinging range depends
on the operation mode. (See
the figure.)
●
The real flap angles are differ
from the display of remote
controller.
Adjusting the vertical blade
(louvre)
Hold the knob and move the louvre.
(You will find a knob on the left-side and the
right-side blades.)
DRY • COOL
FAN