Daikin FHC45B7V1, Operation Manual

Page: 8 / 10

Operation manual
5
FH(Y)B+C(P) + FDY(P) + FBQ + FCQ + FDQ
Split system air conditioners
4PW10622-1C
How to clean the suction grille
(See figure 6) (for FH(Y)C and FCQ only)
1 Open the suction grille.
Push both knobs simultaneously and carefully lower the grille.
(Identical procedure for closing.)
2 Detach the suction grille.
Open the suction grille 45 degrees and lift it upward.
3 Detach the air filter.
Refer to "How to clean the air filter" on page 4 .
4 Clean the suction grille.
Wash with a soft bristle brush and neutral detergent or water,
and dry thoroughly.
5 Reattach the suction grille.
See item 2 "Detach the suction grille." on page 5 .
6 Close the suction grille
See item 1 "Open the suction grille." on page 5 .
How to clean air outlet and outside panels
■
Clean with soft cloth.
■
When it is difficult to remove stains, use water or neutral
detergent.
■
When the blade is extremely contaminated, remove it and clean
or exchange it. (For FH(Y)C and FCQ only.) (Blade for exchange
is optional.)
Start-up after a long stop
■
Confirm the following.
-
Check that the air inlet and outlet are not blocked. Remove
any obstacle.
- Check if the earth is connected.
■
Clean the air filter and outside panels.
-
After cleaning the air filter, make sure to attach it.
■
Turn on the main power supply switch.
-
The control panel display lights when the power is turned on.
- To protect the unit, turn on the main power switch at least
6 hours before operation.
What to do when stopping the system for a long period
■
Turn on FAN OPERATION for a half day and dry the unit.
-
Refer to the manual of the remote controller.
■
Cut off the power supply.
-
When the main power switch is turned on, some wattage is
being consumed even if the system is not operating.
- The remote controller display is turned off when the main
power switch is turned off.
Disposal requirements
Dismantling of the unit, treatment of the refrigerant, oil and eventual
other parts, should be done in accordance with the relevant local and
national regulations.
N
OTES
NOTE
When the suction grille is very dirty, use a typical
kitchen cleaner and let it sit for about 10 minutes.
Then, wash it with water.
NOTE
Do not use gasoline, benzene, thinner, polishing
powder, liquid insecticide. It may cause discoloring or
warping.
Do not let the indoor unit get wet. It may cause an
electric shock or a fire.