Daikin FAQ71BVV1B, Operation Manual

Page: 11 / 14

English 7
1. Open the front panel.
Place your fingers on the panel protrusions on
the left and right sides of the main unit and open
until the panel stops.
2. Remove the front panel.
Push the axes on either side of the front panel
towards the center of the main unit and remove.
(You can also remove it by sliding the front panel
either to the left or right and pulling it forward.)
3. Clean the front panel.
• Wipe gently with a soft wet cloth.
• Only use neutral cleaning agents.
• After washing off, wipe off any excess water
and dry in a shaded location.
4. Attach the front panel.
Set the keys of the front panel into the slots and
push them in all the way.
Close the front panel slowly in this state.
START UP AFTER A LONG STOP
Confirm the following
• Check that the air inlet and outlet are not blocked.
Remove any obstacle.
• Check if the earth is connected.
Might there be a broken wire somewhere?
Contact your dealer if there are any problems.
Clean the air filter and outside panels
• After cleaning the air filter, make sure to attach it.
Turn on the main power supply switch
• The display on the remote controller will be shown
when the power is turned on.
• To protect the unit, turn on the main power switch
at least 6 hours before operation.
WHAT TO DO WHEN STOPPING THE SYS-
TEM FOR A LONG PERIOD
Turn on FAN OPERATION for a half day and dry
the unit.
• Read the operation manual that came with the
remote controller.
Cut off the power supply.
• When the main power switch is turned on, some
watts of electricity is being used even if the sys-
tem is not operating.
Turn off the main power supply switch for saving
energy.
• The display on the remote controller will vanish
when the main power switch is turned off.
Clean the air filter and the exterior.
• Be sure to replace the air filter to its original place
after cleaning. Refer to “MAINTENANCE”.
The following symptoms do not indicate air condi-
tioner malfunction
I. THE SYSTEM DOES NOT OPERATE
• The system does not restart immediately
after the ON/OFF button is pressed.
If the OPERATION lamp lights, the system is in
normal condition.
It does not restart immediately because a safety
device operates to prevent overload of the sys-
tem. After 3 minutes, the system will turn on
again automatically.
• The system does not restart immediately
when TEMPERATURE SETTING button is
returned to the former position after pushing
the button.
If the OPERATION lamp lights, the system is in
normal condition.
It does not restart immediately because a safety
device operates to prevent overload of the sys-
tem. After 3 minutes, the system will turn on
again automatically.
• The system does not start when the display
shows “
” and it flashes for few sec-
onds after pressing an operation button.
This is because the system is under centralized
control. Flashes on the display indicates that the
system cannot be controlled by the remote con-
troller.
8. NOT MALFUNCTION OF THE AIR
CONDITIONER