background image

English

6

ONLY A QUALIFIED SERVICE PERSON IS 
ALLOWED TO PERFORM MAINTENANCE

IMPORTANT!

• BEFORE OBTAINING ACCESS TO TERMINAL 

DEVICES, ALL POWER SUPPLY CIRCUITS 
MUST BE INTERRUPTED

To clean the air conditioner, be sure to stop oper-
ation, and turn the power switch off. Otherwise, an 
electric shock and injury may result.

Do not wash the air conditioner with water
Doing so may result in an electric shock.

Be careful with a scaffold or staging
Caution must be exercised because of work at a 
high place.

HOW TO CLEAN THE AIR FILTER

Clean the air filter when the display shows “

”. 

Increase the frequency of cleaning if the unit is 
installed in a room where the air is extremely 
contaminated.
(As a yardstick for regulating yourself, consider 
cleaning the filter once every two weeks.)

1. Open the front panel.

Place your fingers on the panel protrusions on 
the left and right sides of the main unit and open 
until the panel stops.

2. Pullout the air filter.

Push up the tab in the center of the air filter 
slightly then pull out in a downward direction.

3. Clean the air filter.

Use vacuum cleaner 

A)

 or wash the air filter with 

water

 B).

A)

Using a vacuum cleaner

7. MAINTENANCE                         

(FOR SERVICE PERSONNEL)

B)

Washing with water
When the air filter is very 
dirty, use soft brush and 
neutral detergent.

Remove water and dry in 
the shade.

NOTE

Do not wash the air conditioner with hot water of 
more than 50°C, as doing so may result in discol-
oration and/or deformation.

Do not expose it to fire, as doing so may result in 
burning.

4. Attach the air filter.

Once cleaning is done be sure to replace the air 
filter as it was.

5. After turning on the power, press AIR FILTER 

CLEANING TIME ICON RESET BUTTON.

The display “ 

” vanishes.

HOW TO CLEAN THE AIR OUTLET AND 
EXTERIOR

Clean with soft cloth.

When it is difficult to remove stains, use water or 
neutral detergent.

NOTE

Do not use gasoline, benzene, thinner, polishing 
powder, liquid insecticide. It may cause discolor-
ing or warping.

Do not use water or air of 50°C or higher for clean-
ing air filters.

HOW TO CLEAN THE FRONT PANEL

You can remove the front panel to clean it.

NOTES

Hold the front panel firmly so that it does not fall.

Do not use water over 50 °C, benzine, gasoline, 
thinner, or other volatile substances, polishing 
powder, or hard scrub brushes to clean the panel.

Make sure the front panel is solidly in place.

1. Open the front panel.

Place your fingers on the panel protrusions on 
the left and right sides of the main unit and open 
until the panel stops.

01_EN_3PN05140-5E.fm  Page 6  Friday, December 5, 2003  11:15 AM

Summary of Contents for FAQ71BUV1B x 2












Reviews: