![background image](http://html1.mh-extra.com/html/daikin/faa71auveb/faa71auveb_operation-manual_4704593011.webp)
English
10
1. Open the front panel.
Place your fingers on the panel protrusions on
the left and right sides of the main unit and open
until the panel stops.
2. Pull out the air filter
Push up the tab in the center of the air filter
slightly, then pull out the filter downward.
NOTE
•
After removing the filter, do not touch the heat
exchanger to avoid cutting your hand.
3. Clean the air filter.
Use vacuum cleaner
A)
or wash the air filter with
water
B)
.
A)
Using a vacuum cleaner
B)
Washing with water
When the air filter is very
dirty, use soft brush and
neutral detergent.
Remove water and dry in the shade.
NOTE
•
Do not wash the air filter with water which is 50°C
or more, as doing so may result in discoloration
and/or deformation.
•
Do not expose it to fire, as doing so may result in
burning.
4. Attach the air filter.
Once cleaning is done be sure to replace the air
filter as it was.
5. Close the front panel.
6. Turn off the indication “
” or “Time to
clean filter” displayed on the remote control-
ler after turning on the power.
•
For details, refer to the operation manual
attached to the remote controller.
The indication can be turned off whether in
operation or at stop.
HOW TO CLEAN AIR INLET, AIR OUTLET,
EXTERIOR, AND REMOTE CONTROLLER
•
Wipe with a soft dry cloth.
•
If a stain cannot be removed, wipe it with a cloth
firmly wringed after soaked in diluted neutral deter-
gent. After that, wipe the area with a dry cloth.
NOTE
•
Do not use gasoline, benzene, thinner, polishing
powder, or commercially supplied liquid insecti-
cide. This may cause discoloration or deformation.
•
Do not use water which is 50°C or more. This may
cause discoloration or deformation.
HOW TO CLEAN THE FRONT PANEL
You can remove the front panel to clean it.
CAUTION
•
Hold the front panel firmly so that it does not fall.
•
Do not use water which is 50°C or more, benzene,
gasoline, thinner, or other volatile substances,
polishing powder, or hard scrub brushes to clean
the panel.
•
Do not expose it to fire, as doing so may result in
burning.
•
Make sure the front panel is solidly in place.
1. Open the front panel.
Place your fingers on the panel protrusions on
the left and right sides of the main unit and open
until the panel stops.
2. Remove the front panel.
Push the hook on either side of the front panel
towards the center of the main unit and remove
it.
(You can also remove it by sliding the front panel
either to the left or right and pulling it forward.)
3. Clean the front panel.
•
Wipe gently with a soft wet cloth.
•
Only use neutral cleaning agents.
•
After washing, wipe off the remaining water
completely and dry in the shade.
4PEN465287-1C.book Page 10 Thursday, March 23, 2017 2:47 PM