Operation
DRY · COOL · FAN Operation
The air conditioner operates with the operation mode of your choice.
From the next time on, the air conditioner will operate with the same operation mode.
■
To start operation
■
To stop operation
1. Press
(MoDE]
and select an
operation mode.
• Each pressing of the button
changes the mode setting in
sequence.
r�-*-+7
l°RY COOL
FAN�
2. PressW.
• " [;lD " is displayed on the LCD.
• The OPERATION lamp lights green.
[]
C
0
c::J
3. Press
W
again.
• "(;lD" disappears from the LCD.
• Then OPERATION lamp goes off.
■
To change the temperature
setting
4. Press
[r�PI.
• Press A to raise the temperature
and press v to lower the
temperature.
COOL operation
DRY or
FAN
operation
The temperature
18-32
°
C
setting cannot be
changed.
+
Default Set Temperature Setting
: As per BEE regulation, whenever Air Conditioner will be switched
ON from the remote, the default set temperature will be set as mentioned in below table:
Mode Set temperature before remote switched OFF Set temperature after remote switched ON
Cool
If set temperature < 24
·c
Default set temperature will be 24
°
C
If set temperature >= 24
·c
Default set temperature will remain same
as set prior to remote switched OFF.
Note:
Whenever AC is switched OFF in dry mode and is switched ON from remote, air conditioner will
start in Cool mode and then DRY mode selection can be done using the MODE button.
NOTE
■
Note on COOL operation
• This air conditioner cools the room by releasing heat in the room outdoors.
Therefore, cooling performance may fall in higher outdoor temperatures.
■
Note on DRY operation
• Eliminates humidity while maintaining the indoor temperature as much as possible.
It automatically controls temperature and airflow rate, so manual adjustment of these
functions is unavailable.
■
Note on FAN operation
• This mode is valid for fan only.
■
Recommended temperature setting
• For cooling: 26-28
°
C
