Procedure for Software Upload/Download
ESIE07-05
3–4
3
1
3
4
5
1.2
Copy from the Software Key to pCO²
■
Switch off the pCO
2
and remove the "expansion memory" cover with a screwdriver (see "Copy from
pCO² to the Software Key" on page 3–5/Fig. 1)
■
Set the key selector on
■
Insert the key in the corresponding pin connector as shown. (see "Copy from pCO² to the Software
Key" on page 3–5/Fig. 2)
■
Press simultaneously the buttons UP an DOWN then supply power to the pCO
2
■
Check the LED on the key is on (red color
)
■
Wait until the request of copying appears on the LCD display, then release the buttons and confirm
by pressing ENTER.
■
The data transfer operation takes about 50s using the 1MB key and 100s using the 2MB one.the
display will show a progressive series of numbers.
■
Once copied the application program starts, then switch off the pCO
2
, remove the key, put the
cover in its place and switch on the pCO
2
again,
■
Now the pCO
2
works with the program transferred by the key.
ESIE07-05.book Page 4 Friday, December 21, 2007 3:21 PM
