Installer reference guide
31
EHBH/X16
Daikin Altherma - Low Temperature Split
4P313776-1 – 2012.05
8 Configuration
8
Configuration
8.1
Overview: Configuration
If you do NOT configure the system correctly, it might NOT work as
expected. You can configure the system with the user interface.
When you turn ON the user interface for the first time (via the indoor
unit), a quick wizard starts to help you configure the system. If
necessary, you can also make changes to the configuration
afterwards.
The installer can prepare the configuration off-site on PC and
afterwards upload the configuration to the system with the PC
configurator. See "8.1.1 To connect the PC cable to the switch
box" on page 31 for more information about the connection.
The configuration influences the following:
Q
The calculations of the software
Q
What you can see on and do with the user interface
Legend for the settings tables:
Q
#
: Breadcrumb in the menu structure
Q
Code
: Code in the overview settings
When the installer settings are changed, the system will request to
confirm. When confirmation is complete, the screen will shortly turn
OFF and "busy" will be displayed for several seconds.
The most commonly used installation settings are accessible through
the menu structure. Their location is mentioned by the breadcrumb
indication (#). Additionally, all installer settings can also be found in
Menu structure: Installer settings.
For access to the setting codes, see "To access the installer
settings" on page 31.
Not all settings are accessible through the menu structure. Some are
only accessible through their code. Then in the table explained
below, the bread crumb is set as N/A (not applicable).
8.1.1 To connect the PC cable to the switch box
1
Connect the cable with USB connection to your PC.
2
Connect the plug of the cable to X10A on A1P of the switch box
of the indoor unit.
3
Pay special attention to the position of the plug!
8.1.2 To access the most used commands
To access the installer settings
1
Set the user permission level to Installer.
2
Go to [A]:
> Installer settings.
To access the overview settings
1
Set the user permission level to Installer.
2
Go to [A.8]:
> Installer settings > Overview settings.
To set the user permission level to Installer
1
Go to [6.4]:
> Information > User permission level.
2
Press
for more than 4 seconds.
Result:
is displayed on the home pages.
To switch between user permission levels (End user and
Extended end user)
1
Go to [6] or any of its submenus:
> Information.
2
Press
for more than 5 seconds.
Result:
The user permission level switches to Adv. end user.
Additional information is displayed and "+" is added to the menu
title.
3
If you do NOT press any button for more than 1 hour or press
again for more than 5 seconds, the user permission level
switches back to End user.
8.1.3 To copy the system settings from the first to
the second user interface
If an optional user interface is connected, the installer must first
proceed below instructions for the proper configuration of the two
user interfaces.
This procedure offers you also the possibility to copy the language
set from one user interface to the other one: e.g. from EKRUCAL2 to
EKRUCAL1.
1
When power is turned on for the first time, both user interfaces
display:
2
Push
for 4 sec. on the user interface on which you want to
proceed to the quick wizard.
3
The quick wizard will guide you (see Quick wizard)
4
For proper operation of the system, the local data on the two
user interfaces must be the same. If this is not the case, both
user interfaces will display:
A1P
X10A
2
3
4
5
H JST
INFORMATION
During the quick wizard, the second user interface displays
Busy and will not be possible to operate.
Summary of Contents for ERHQ011BA
Page 83: ......