14
Installation Manual 3P291714-1
DCM601A51 intelligent Touch Manager
English
2
Connection
This chapter describes the procedure for connecting the intelligent Touch Manager with
DAIKIN air conditioning devices and other equipment.
In addition to air conditioners, the intelligent Touch Manager can monitor and control a
wide range of equipment. However, the required connection procedures vary depending
on the equipment to be connected.
Required proce-
dures
• 2.2 Connecting DIII-NET-compatible air conditioning equipment
•
2.7 Connecting power supply
Equipment-spe-
cific procedures
• 2.3 Connecting a LAN cable
•
2.4 Connecting I/O module
•
2.5 Connecting an emergency stop input device or electric energy meters
•
2.6 Connecting iTM plus adaptors
WARNING
•
Do not turn the power supply on until all connections are made. Also, make
sure that the local circuit breaker, if available, is turned off. Doing so may cause
an electric shock.
•
After completing connections, check again that all wires are connected cor-
rectly before turning on the power supply.
2.1
Removing terminal cover from rear face
<Removing terminal cover>
Before you start any of these connection procedures,
remove the terminal cover from the rear face. To do
so, remove two screws using a Phillips screwdriver.
2.2
Connecting DIII-NET-compatible air conditioning equipment
DIII-NET is a unique air conditioning equipment communication capability developed by
DAIKIN. Using DIII-NET, you can centrally control multiple DAIKIN DIII-NET-compatible air
conditioning devices by connecting them to your intelligent Touch Manager.
WARNING
•
Be sure to perform this procedure with the power supply turned off. Doing so
may cause an electric shock.
•
Do not clamp the cables located outside the unit with high-current power
cables.
01_EN_3P291714-1.indd 14
5/18/2011 1:45:51 PM