English
10
•
If the PROGRAM DRY OPERATION is
used when the indoor temperature is low,
frost forms on the heat exchanger of the
indoor unit. In this case, the system auto-
matically switches to DEFROST OPERA-
TION for a while.
For programming TEMPERATURE, FAN
SPEED and AIRFLOW DIRECTION, follow
the procedure shown below.
TEMPERATURE SETTING
Press TEMPERATURE SETTING BUT-
TON and program the setting tempera-
ture.
Each time this button is pressed,
setting temperature rises 1
°
C.
Each time this button is pressed,
setting temperature lowers 1
°
C.
•
Temperature can not be set in the FAN
operation.
In case of automatic operation
Each time this button is pressed,
setting temperature shifts to “H”
side.
Each time this button is pressed,
setting temperature shifts to “L”
side.
[
°
C]
•
The setting is impossible for fan operation.
NOTE
•
The setting temperature range of the
remote controller is 16°C to 32°C.
•
After settings are changed or operation is
turned ON/OFF, make sure that the receiv-
ing tone of the indoor unit makes a beep-
ing sound.
ADJUSTMENT
DOWN
UP
DOWN
UP
DOWN
UP
H
M
L
Setting
temperature
25
23
22
21
19
FAN SPEED CONTROL
Press FAN SPEED CONTROL BUT-
TON.
Low, Middle or High fan speed can be
selected.
•
The microchip may sometimes control the
fan speed in order to protect the unit.
•
The airflow rate may be changed automat-
ically depending on the indoor tempera-
ture.
The fan may be stopped, but this is normal.
•
It may take some time until the airflow
switch is completed, but this is normal.
•
The airflow rate cannot be set to “auto-
matic”.
AIRFLOW DIRECTION
ADJUST
•
There are 2 ways of adjusting the airflow
direction.
(When the operation stops, the airflow
flaps at the air outlet (vertical airflow direc-
tion adjustment flaps) close automatically.)
FAN
SWING
A. Up and down direction
B. Left and right direction
01_EN_3P302565-1.fm Page 10 Monday, February 13, 2012 4:09 PM