5
English
9
FAN SPEED CONTROL BUTTON
Press this button to select the fan speed,
Low or Middle or High, of your choice.
10
TEMPERATURE SETTING BUTTON
Use this button for SETTING TEM-
PERATURE (Operates with the front
cover of the remote controller closed.)
11
SIGNAL TRANSMITTER
This sends the signals to the indoor
unit.
12
TEMPERATURE ADJUSTMENT/
PROGRAMMING TIMER BUTTON
Use this button for temperature setting
and programming “START and/or
STOP” time. (Operates with the front
cover of the remote controller opened.)
13
TIMER MODE START/STOP BUT-
TON
Refer to page 12.
14
TIMER RESERVE/CANCEL BUTTON
Refer to page 12.
15
AIRFLOW DIRECTION ADJUST
BUTTON
Refer to page 10.
16
OPERATION MODE SELECTOR
BUTTON
Press this button to select OPERA-
TION MODE. “
” (COOLING), “
”
(HEATING), “
” (AUTOMATIC),
“
” (FAN),
“
”
(PROGRAM DRY).
17
FILTER SIGN RESET BUTTON
Refer to the section of MAINTE-
NANCE in the operation manual
attached to the indoor unit.
18
INSPECTION/TEST OPERATION
BUTTON
This button is used only by qualified ser-
vice persons for maintenance purposes.
Do not operate this button during nor-
mal use.
19
EMERGENCY OPERATION SWITCH
This switch is readily used if the
remote controller does not work.
20
RECEIVER
This receives the signals from the
remote controller.
21
OPERATING INDICATOR LAMP (Red)
This lamp stays lit while the air
conditioner runs. It flashes when the
unit is in trouble.
22
TIMER INDICATOR LAMP (Green)
This lamp stays lit while the timer is
set.
23
AIR FILTER CLEANING TIME
INDICATOR LAMP (Red)
Lights up when it is time to clean the
air filter.
24
DEFROST OPERATION LAMP
(Orange)
Lights up when the defrosting opera-
tion has started. (For cooling only type
this lamp does not turn on.)
NOTES
•
For the sake of explanation, all indica-
tions are shown on the display in Figure 1
contrary to actual running situations.
•
Fig. 1-2 shows the remote controller with
the front cover opened.
•
If the AIR FILTER CLEANING TIME
INDICATOR LAMP lights up, clean the air
filter as explained in the operation man-
ual provided with the indoor unit.
After cleaning and reinstalling the air fil-
ter, press the FILTER SIGN RESET BUT-
TON on the remote controller. The AIR
FILTER CLEANING TIME INDICATOR
LAMP on the receiver will go out.
•
The DEFROST OPERATION LAMP will
flash when the power is turned on. This is
not a malfunction.
•
Do not place the remote controller where
subject to direct sunlight. LCD will get dis-
colored and may fail to display information.
[CAUTIONS]
Before cleaning, be sure to press the ON/
OFF BUTTON to shut OFF the power for
safety.
01_EN_3P302565-1.fm Page 5 Monday, February 13, 2012 4:09 PM