19
1. Open the front panel. (page 18.)
• Hold the panel at the recesses on the
main unit (2 recesses on right and left
sides) and lift it until it stops.
2. Pull out the air filters.
• Push the filter tab at the center of each air filter a little upwards, then pull it down.
3. Take off the Titanium Apatite
Photocatalytic Air-Purifying Filter.
• Hold the recessed parts of the frame and
unhook the four claws.
4. Clean or replace each filter.
See figure.
• When shaking off remaining water, do not
wring the filter.
5. Set the air filter and Titanium
Apatite Photocatalytic Air-Purifying Filter
as they were and close the front panel.
• Insert claws of the filters into slots of the front panel.
Close the front panel slowly and push the panel at the
3 points. (1 on each side and 1 in the middle.)
• The air filter and the Titanium Apatite Photocatalytic
Air-Purifying Filter have a symmetrical form in the
horizontal direction.
Air Filter
1. Wash the air filters with water or clean them
with vacuum cleaner.
• If the dust does not come off easily, wash them with neutral
detergent thinned with lukewarm water, then dry them up in the
shade.
• It is recommended to clean the air filters every two weeks.
Titanium Apatite Photocatalytic
Air-Purifying Filter.
The Titanium Apatite Photocatalytic Air-Purifying Filter can be renewed by washing it with water
once every 6 months. We recommend replacing it once every 3 years.
Filters
Recess on
main unit
Air filter
Titanium Apatite
Photocatalytic
Air-Purifying Filter
Filter frame
Tab
Tab
Summary of Contents for ATXL25J2V1B
Page 5: ...4 Names of parts Indoor Unit ...
Page 27: ......
