5
Indoor Unit
Installing The Mounting Plate
• The mounting plate should be installed on a wall which can support the weight of the indoor unit.
1) Temporarily secure the mounting plate to the wall, make sure that the panel is completely level, and mark the
boring points on the wall.
2) Secure the mounting plate to the wall with screws.
Recommended mounting-plate retention spots and Dimensions
Use a tape measure
as shown.
f Recommended mounting plate
Place a leveler
Position the end of
retention spots (7 spots in all)
on these tabs.
tape measure at I>
-------;--:=:'fsl-: . .
-
•
•
�[;�. • •
B
Drain hose
position
Through-the-wall hole ,j)6Smm
����
�
O'
·--�-.
-�]!
.s
�� �;;p
i
Tl
p.,_
Place the pipe port
cover in this pocket.
Liquid pipe end
t ��':1o����: (��:;?/�:�
1100
610
Liquid pipe end
Gaspipeend
Drainhose
position
Applicable Unit Size*
Type
[H] X [W] X [D] A
B
C
(i)
298
X
800
X
229
800 116.5 116.5
®
298
X
821
X
235
821 128 126.5
®
298
X
885
X
229
885 116.5 116.5
©
298
X
906
X
235
906 127 127.5
* Unit size available on name plate.
Table No.4
Applicable Unit Size*
Type
I
[H] X [W] X [D]
®I
310
X
1100
X
239
* Unit size available on name plate.
Table No. 5
All dimensions are in mm.
Drilling A Wall Hole And Installing Wall Embedded Pipe
L'.t
WARNING---------------
For metal frame or metal board walls, be sure to use a wall embedded pipe and wall hole cover in the feed-through hole
to prevent possible heat, electrical shock, or fire.
1) Drill a feed-through hole with a 65mm
diameter through the wall at a
downward angle toward the outside.
2) Insert a wall embedded pipe into the hole.
3) Insert a wall hole cover into wall pipe.
Inside� Outside
Wall embedded
pipe (field supply)
Wall hole cover
(field supply)
065
Summary of Contents for ATKL50UV16V3
Page 20: ......
