SiBE04-401
Instruction
System Configuration
83
26
Check
■
Before a long idle period
1. Operate the “fan only” for several hours on a fine day to dry out the
inside.
• Press “MODE” button and select “fan”operation.
• Press “ON/OFF” button and start operation.
2. Clean the air filters and set them again.
3. Take out batteries from the remote controller.
4. Turn OFF the breaker for the room air conditioner.
NOTE
Check that the base, stand and other fittings of the outdoor unit are not decayed or corroded.
Check that nothing blocks the air inlets and the outlets of the indoor unit and the outdoor unit.
Check that the earth wire is not disconnected or broken.
Check that the drain comes smoothly out of the drain hose during COOL or DRY operation.
• If no drain water is seen, water may be leaking from the indoor unit. Stop operation and consult the ser-
vice shop if this is the case.
• Operation with dirty filters:
(1) cannot deodorize the air. (2) cannot clean the air.
(3) results in poor heating or cooling. (4) may cause odour.
• To order air purifying filter with photocatalytic deodorizing function contact to the service shop there
you bought the air conditioner.
• Dispose of old filters as burnable waste.
Item
Part No.
Air purifying filter with photocatalytie deodorizing
function. (without frame) 1 set
KAF918A44
Air purifying filter with photocatalytie deodorizing
function. (with frame) 1 set
KAF918A43
Summary of Contents for ARKH20CVMB9
