Daikin A2 F, Installation And Operating Instructions Manual

Page: 64 / 64

008.1546499_01 03/2018 – EN
Copyright © ROTEX
14 For the chimney sweep
www.daikineurope.com
www.rotex-heating.com
14 For the chimney sweep
14.1 Data for designing the flue gas pipe
Device Burner
load in kW
Rated output in kW Flue gas mass flow in
g/s
Heating oil/EL
Flue gas temperature in °C Available pum-
ping pressure in
Pa
50/30 °C 80/60 °C 50/30 °C 80/60 °C
A2 F 18H 8.5 8.3 3.90 34 52 100
18.2 17.7 8.36 46 68 200
A2 F 24H 10.9 10.6 5.01 34 52 100
24.7 24.1 11.35 46 70 200
A2 F 32H 12.8 12.5 5.88 34 52 100
32.2 31.4 14.79 46 72 200
Tab. 14-1 Triple values for chimney design (flue gas flow dependent on heat output, see Bild 4-6 )
14.2 Emissions measurement
The control measurement can be made by an easily selectable auto-
matic function (see also enclosed "Control system instructions").
1 Press the Exit button for at least 5 secs.
è The " Special Level " menu is displayed.
2 Use the rotary button to select the "Emissions measurement"
program.
3 Confirm the selection with a brief push of the rotary button.
è
The following load types are available for selection:
– Off: The emission measurement is switched off, any heat ge-
nerators switched on by the A2 F control functions continue
to be regulated normally.
– Base load: The heat generator is switched on and operated
at the minimum output of the heat generator, irrespective of
the set operating mode.
– Full load: The heat generator is switched on and operated at
the maximum output of the heat generator, irrespective of
the set operating mode.
4 Use the rotary button to select the "Full Load" load type, but do
not confirm it .
è Display: "Full Load"
è The burner is turned on for 30 min. and is regulated at maxi-
mum load.
5 Use the rotary button to select the "Base Load" load type, but
do not confirm it .
è
Display: "Base Load"
è
The modulating oil burner runs at minimum output for
30 mins.
6 Cancellation and jump back by:
– Pushing the Exit button or rotary switch again
– Selection of a different menu using the rotary switch and
confirmation.
Special Level
Emissions measurement
Manual Operation
Emissions measurement
Off
Emissions measurement
Base Load
Emissions measurement
Full Load
Emissions measurement
Full Load
T-HS
T-HS
T-HS
T-HS
Bild 14-1 Symbolic brief instructions for emission measurement