Daihen OTC ARXIS pulse P403L, Owner'S Manual, Page: 77 / 188

P
REPARING
W
ELDING
JOB
W
ELDING
C
ONDITION
C
HAPTER
6
75
Chapter 6 W
elding Condition
6.4 Preparing Welding JOB
This section explains the setting process of basic welding JOB.
6.5 Memory Function of Welding JOB
This section explains the memory function of welding JOB.
The welding power source is equipped with the function to register the welding JOB and reads them out for use. The
number of welding JOB that are able to be registered are 100 at maximum. Single welding condition can contain the
following information at registration:
• Welding mode selected by the touch panel (Shield gas/Wire/Crater/Penetration control, etc.)
• Welding current/voltage for each welding sequence ( 6.6.3
-
Setting welding parameter)
• Part of internal function ( 6.1.3
-
Internal function)
NOTE
•
When the analog remote control is connected to the machine, even if the stored welding
condition is read, the set values of the analog remote control apply to the welding current
and welding voltage of welding condition.
Check welding material suitable for the welding condition
( 10.3
-
Materials for Setting Welding JOB)
↓
Setting wire material, wire diameter, shield gas, and Manual/Auto.
( 6.6.1
-
Welding mode setting)
↓
Setting crater treatment
( 6.6.4
-
Crater setting
-
)
↓
Setting pre-flow (Setting gas discharge time)
( 6.6.3
-
Setting welding parameter)
↓
Setting start condition (Setting welding current/voltage)
( 6.6.3
-
Setting welding parameter)
↓
Setting welding condition (Setting welding current/voltage)
( 6.6.3
-
Setting welding parameter)
↓
Setting crater condition (Setting welding current/voltage)
( 6.6.3
-
Setting welding parameter, 6.6.4
-
Crater setting)
↓
Setting post-flow (Setting gas discharge time)
( 6.6.3
-
Setting welding parameter)
↓
Registering the welding JOB set above as necessary
( 6.5
-
Memory Function of Welding JOB)
CAUTION
•
The welding JOB (electronic data) stored by this function are susceptible to occurrence
of static electricity, impact, repair, etc., and there is a possibility that the stored
contents may be changed or lost. BE SURE TO MAKE A COPY FOR IMPORTANT DATA.
•
Please note that OTC will not be liable for any alteration or loss of electronic
information.
•
The memory function of welding condition is not available if the welding process is "DC
TIG" or "MMA".