Daihen OTC ARXIS pulse P403L, Owner'S Manual

Page: 89 / 188

S
ETTING
W
ELDING
JOB
W
ELDING
C
ONDITION
C
HAPTER
6
87
Chapter 6 W
elding Condition
6.6.3 Setting welding parameter
This section explains how to set the welding parameter (gas discharge time, welding current/voltage). The welding
parameters are set according to the welding sequence.
6.6.3.1 Welding sequence
The basic welding sequence is the process of PRE FLOW, MAIN CONDITION, and POST FLOW. To this sequence, start
condition and crater-fill condition can be added depending on the crater setting. The welding parameters such as gas
discharge time, welding current and voltage should be set to this sequence.
Each sequence process has the following description:
6.6.3.2 Basic configuration of PARAMETER screen
Process Description
PRE FLOW It is the sequence to discharge gas before the welding starts.
START CONDITION It is the sequence to process the welding start.
MAIN CONDITION It is the welding sequence.
CRATER -FILL CONDITION It is the sequence to process the crater part.
POST FLOW It is the sequence to discharge gas after the welding completes.
No. Name Function
1
Welding Current (%) Against Main
Condition Displays the welding current percentage against the Main Condition’s welding current.
When the intended item is selected, the set value can be changed.
2 Welding Current / Welding Voltage
Displays the welding current and voltage for each process.
When the intended item is selected, the set value can be changed.
START
CONDITION
CRATER-FILL
CONDITION
FLOW
POST
CONDITION
MAIN
FLOW
PRE
1
2
4 7 5 6
9
10
3
11
8