2.1 Condition Settings
2-5
2.1.7 Controlling the common switch using an input signal
This function is used to control the [Operation Disabled / Enabled switch] (Common switch) located on the most
upper right side on the screen by the external input signal.
When it is not necessary to control the common switch using the external input signal, this setting is unnecessary.
But, if it is necessary to confirm the status of the common switch from external devices, please refer to [2.1.8
Checking the status of the common switch].
On the same screen, put cursor on [Signal of common SW], and set it to the
desired status.
1
Settings
Details
Disabled
The touch panel controls common switch.
Enabled
Common switch is controlled by the external input signals.
(1)
When enabled, the following settings are disabled.
[The status of the common switch when turning ON the primary power]
This depends on the signal status at the timing of the power ON.
[Operation of the common switch]
Because the common switch is controlled by the input signal, the
operation for this switch on the touch panel is ignored.
(2)
When enabled, the graphical icon of the switch on the most upper right side is
displayed like shown below. (Hatched icon)
2
If [Signal of common SW] is set to [Enabled], please allocate an input signal that is
used to control the common switch on this screen. Put the cursor to [Input of
common SW], and allocate one input signal.
When the allocated signal is OFF, the common switch is [Disabled]
When the allocated signal is ON, the common switch is [Enabled]
3
By pressing f8 <Input Ref>, the allocation of the input signals can be checked.
4
Upon completion of settings mentioned above, press f12 <Complete> key.
IMPORTANT
When controlling the Disabled/Enabled status of the common switch using the input signal,
there would be a possibility in which the operator presses the button in mistake. Therefore,
please use the function carefully considering the enabling conditions etc.
