4
3
INSTALLATION
The intelligent thermal imaging thermal hybrid dome adopts four installation modes which are
wall mount, hang mount, corner mount and pole mount.
Attention:
The installation surface should meet the following installation conditions:
The installation surface is thick enough to install expansion bolt.
The installation surface should sustain at least 8X weight of the thermal hybrid dome.
3.1
Wall Mount Installation
Figure 3-1
Figure 3-2
Step 1
Dig holes on the installation wall, fix the expansion bolt, and tighten the hex nut, as it is shown in
Figure 3-2 (1).
Step 2
Screw the quick installation connector into the wall mount bracket and fix it with stainless screws,
as it is shown in Figure 3-2 (2).
Step 3
Buckle it into the safety hook, connect to cable and use insulated rubber tape to make the device
waterproof, as it is shown in Figure 3-2 (3).
Attention:
Please make sure the safety hook is installed, otherwise the thermal hybrid dome may fall
and cause accident due to instability! Please refer to the safety hook installation instruction
in the accessories bag for more details.
