13
d. Connect the other end of the waterproof connector to the network port and rotate it
clockwise to lock the network port and waterproof connector firmly.
e. Slide the Waterproof Locking Cover over the main body of waterproof connector and
rotate it clockwise to seal the connection.
6. Align the TOP of the camera module to the TOP of the mounting template, then pull the
cables through the installation medium or through the side export port on the camera module.
7. Align the three screw holes in camera module to the three plastic expansion bolt holes in the
installation medium, and then insert a self-tapping screws into each expansion bolts and
secure firmly.
8. Route the cables from the top of the camera through the installation medium or through the
side wiring exit on the pedestal.
9. Connect the external cables from the camera to the appropriate cables for Ethernet and
power.
10. Adjust the camera and the lens according to the application requirements of the location.
a. Loosen, but do not remove the set screws on either side of the bracket that holds the
camera.
b. Tilt the camera to adjust the tilt angle (0° to +75°). Tighten the two locking screws on
the bracket to lock the tilt angle.
c. Rotate the camera module to adjust image pan orientation (0° to +355°).
d. Place the dome cover over the camera to ensure that the cover does not obstruct the
camera.
11. Place the dome cover over the camera and align the holes on the cover to the holes and
pedestal. Insert a hex bolt into each hole and secure the cover to the pedestal with the hex
key.
12. Supply power to the camera.