5. Apply the mounting template to the installation medium. Pre-drill the three perimeter holes as
marked on the template for the expansion bolts, using a drill bit that is no wider than the
expansion bolt.
6. If routing wires through the installation medium, drill the center hole to route the cables from the
camera through the installation medium.
7. Insert an expansion bolt into each pre-drilled perimeter hole.
8. Attach the waterproof network connector if the camera is used outdoors.
Figure 4-3
a. Place the wide side of the rubber ring onto the end of the network cable extending out from
the camera.
b. Pull the waterproof cable end without the Ethernet connector through the body of the
Waterproof Connector. Thread the cable through the Fixing Rubber Ring and the Waterproof
Locking Cover.
c. Attach the male Ethernet connector to the network cable coming from the camera. Ensure the
Waterproof Connector shroud covers the Ethernet connection.
d. Connect the other end of the waterproof connector to the network port and rotate it clockwise
to lock the network port and waterproof connector firmly.
e. Slide the Waterproof Locking Cover over the main body of waterproof connector and rotate it
clockwise to seal the connection.
9. Align the TOP of the camera module to the TOP of the mounting template, then pull the cables
through the installation medium or through the side export port on the camera module.
10. Align the three screw holes in camera module to the three plastic expansion bolt holes in the
installation medium, and then insert a self-tapping screws into each expansion bolts and secure
firmly.
11. Connect the external cables from the camera to the appropriate cables for Ethernet and power.
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
