10
Figure 2-3
Step 6
Adjust the X-Y-Z axis module to turn the device to the proper monitor angle. Please follow the
steps listed below to adjust.
z
Slightly loose the screws at the two sides of the X-Y-Z module manually, you can adjust the
module tilt rotation angle (15
°～
90
°
).
z
Slightly loose the screw of the pressing slice, you can adjust the video rotation angle of the
module (0
°～
355
°
)
z
Adjust the turning ring of the pedestal, you can adjust the module pan rotation angle (
0
°～
355
°
).
Please note, the screws in the following figure are the optical adjustment component.
Please make sure it is outward and do not allow it to touch the X-Y-Z axis module. See
Figure 2-4
Figure 2-4
Step 7
Put the dome cover back and then put the three inner hexagon screws into the holes of the
device. Use the inner hexagonal wrench to fasten these three screws. See Figure 2-5
