3
Device Installation
3.1
Installation Preparation
3.1.1 Check Installation Space and Intension
Please make sure the installation environment has enough space to install the thermal hybrid
speed dome and its corresponding bracket.
Please make sure the ceiling and wall where the device is installed can support the thermal
hybrid dome and its corresponding installation component. It shall sustain the 8X weight of the
thermal hybrid dome and its mounting component.
3.1.2 About cable
Select required video cable
75 ohm impedance
Full cable with copper conductor
95% knitted copper shield
International Model
Max Transmission Distance
(Ft\M)
RG59/U
750Ft (229M)
RG6/U
1,000Ft (305M)
RG11/U
1,500Ft (457M)
Table 3-1
Select required service cable
Caution
It is recommended to install the matched power within 5m from the device if it is allowed; but if
not, then it needs to extend the power supply cable, but it has to guarantee the voltage of the
device input port (thermal hybrid dome output cable) is no lower than AC24V
±
20%.
3.2
Install SD Card and Reset Device (Optional)
Note
Please implement SD installation when the device is equipped with SD card slot and it
needs to use SD card.
Please cut off the device power before installing SD card.
Step 1
Loosen the screw on the lower window cover.
Open the lower cover and then you can see the SD card slot and reset button, which is shown in
Figure 3-1.