4
2.4
Dial Switch Setup (Analog Speed Dome)
The following operation is based on the ceiling mount speed dome. Here we are going to set
speed dome address, baud rate and etc. There are two dial switches on the PTZ for you to set
address, baud rate and etc. See Figure 2-2.
Figure 2-2
2.4.1 Dial Switch Setup for Intelligent Speed Dome
Before you control speed dome, please set the speed dome address, baud rate, parity.
Otherwise, you cannot control the device! See Figure 2-3.
Open speed dome transparent enclosure, you can view the dial switch buttons on the PTZ main
board. You can follow the steps listed below to set the speed dome address, baud rate, and
parity.
Please note you need to restart the device to activate the new setup!
For wall mount speed dome, you need to take out the packing material EPE, set the dial switch
buttons and then put it back to the transparent enclosure module.
Figure 2-3
