6
Figure 2-2
Note:
Motorized vari-focal series devices are equipped with motorized lens by default, which
doesn
’t need manual adjustment; meanwhile the devices with two direction buttons support
zoom and focus via the two direction buttons on the panel.
You can connect the analog output port to the TV monitor to check image via analog output
cable.
Press the reset button for 4 to 5 seconds to realize reset function for the device.
3. Install the lower cover back in place, twist back the screw and lock it firmly.
Step 2
Fix the device on the installation surface.
1. Stick the installation position map on the installation surface (wall or ceiling), dig bottom holes
of expansion bolt according to the hole sites marked on the installation position map.
2. Open the accessories bag, take out expansion bolt and insert it into the hole you just dug,
lock it firmly.
3. Open the accessories bag, take out installation screws. Align the screw hole of the device
bottom with the mounting hole sites, and then put the mounting screws into the screw holes
and lock them firmly.
The device sun shield can be moved back and forth, it needs to tighten the fixing screw on
the sun shield after fixing the device.
Step 3
Plug the external cables of the device properly according to the use requirements.
Connect the corresponding power, audio cable and alarm input output terminal of the device
cable according to the requirement, and then use insulated rubber tape to twine the
connection location to make it waterproof.
Connect the network cable to the corresponding network port of the device cable according
to the step 4 of installing waterproof connector for network port.
Step 4
Install waterproof connector for network port (Optional), which is shown in Figure 2-3.
Note
