10
Mounting the Camera to a Wall
Place the PFB300S Wall Mount against the wall and mark the location of the center hole
and the four perimeter mounting holes.
Pre-drill the four perimeter holes as marked on the wall for the expansion bolts, using a
drill bit that is no wider than the expansion bolt.
Drill a 50-mm (approximately 2 in.) center hole to route the cables, if necessary.
Insert an expansion bolt into each pre-drilled perimeter hole, if necessary.
Wrap several turns of Teflon tape around the threads on the PFA110 Mount Adapter.
Screw the PFA110 Mount Adapter block into the internal thread of the wall mount bracket
until secure. Tighten the set screw on the wall mount to secure the mount adapter.
Use the four (4) hex screws and flat washers to secure the wall mount bracket to the wall.
Summary of Contents for 59232XANR
Page 13: ...2 Dimension ...
