DAF CF65, Service Manual

Page: 142 / 352

CE ENGINE INLET/EXHAUST SYSTEM
4-2
©
200416
Removal and installation
3
ΧΦ65/75/85
series
4
Installing the turbocharger
1. Clean the turbocharger and the oil supply
and discharge pipes.
2. Before installing the turbocharger, check the
following:
-
the turbocharger housing and connector
flange for cracks. See "Technical data"
for rejection standards;
- the turbocharger shaft must be able to
rotate freely;
- the turbocharger shaft must not run out
of true;
- the turbocharger pump and turbine
wheels must not be damaged;
- there must not be an excessive amount
of oil in the compressor side of the
turbocharger. A small amount of oil on
the inside walls of the compressor side
is allowed.
3. Check the adjustment of the turbocharger
wastegate. See "Inspection and adjustment".
4. Check the axial bearing play of the
turbocharger; see "Inspection and
adjustment".
5. Check the radial bearing play of the
turbocharger; see "Inspection and
adjustment".
6. Clean the sealing surfaces.
Note:
Always use new gaskets when installing the
turbocharger.
7. Apply a layer of Copaslip to the exhaust
manifold studs.
8. Fit the turbocharger to the exhaust manifold.
9. Fit the attachment nuts and tighten them to
the specified torque. See "Technical data".
https://www.truck-manuals.net/