DAF CF65, Service Manual

Page: 101 / 352

©
200416 5-9
Removal and installation
CE ENGINE FUEL SYSTEM
ΧΦ65/75/85
series
4
2
10. Fit the attachment bolts (1) in the injector
clamping bracket (2) to secure the injector.
Tighten the attachment bolts alternately to a
torque of 2 Nm.
Note:
Pay special attention to the tightening of the
attachment bolts (1). The tightening must be
carried out alternately; ensure that the
injector clamping bracket (2) is not fitted at
an angle.
11. Apply a thin layer of clean engine oil to the O-
ring of the fuel supply pipe, the screw thread
of the nut and the contact surface of the nut
with the fuel supply pipe.
12. Check the bore of the fuel supply pipe for
foreign matter and damage. Also check
whether the supply bore in the injector is
correctly positioned for the bore, because it
is possible to mount the injector turned
through 180

, so that the fuel supply port is
on the other side.
13. Fit the fuel supply pipe. Press the fuel supply
pipe as far as possible into the bore, with the
ball pointing upwards. Ensure that the O-ring
is not damaged in this process.
Note:
The fuel supply pipe has one or two positioning
balls. The fuel supply pipe can only be installed
with the ball(s) on top, as the bore in the cylinder
head has a groove (1) at the top.
i400806
1
1
2
i400790
1
i400807
https://www.truck-manuals.net/