26
5-4. E1 Error - Error in Water Level Detection
1) Conditions
1
The water level is below the reset level or above the overflow level in the line test mode.
2) The drainage synchronous motor continues to work until the water level drops to the reset level.
3) If the Power button is turned off and on, the error display disappears.
5-5. E2 & E3 Errors - Overflow Error
1-1) Conditions for E2
1
The water supply valve is running when the washer is turned off and the operation is suspended so that the
water level reaches the overflow level.
1-2) Conditions for E3
1
If the errors are detected three times or more during operation, the 'E3' error appears on the display panel.
The operation is suspended, but water continues to be drained.
2
If the water level is first measured to be above the overflow level during the "Baby Care" program, the
heating cycle is skipped. The 'E3' error is displayed on the third occurrence of overflow detection, and the
wash cycle is subsequently suspended. However, the water continues to be drained.
2) The drainage synchronous motor continues to work until the water level drops to the reset level.
3) The "E2" or "E3" error flickers on the display panel.
4) If the Power button is turned off and on, the error display disappears.
5-6. E9 Error - Error in water level sensor
1) Conditions
1
The water level sensor transmits a frequency of 15KHz or lower or 30KHz or higher due to malfunctions.
2) The "E9" error flickers on the display panel.
3) The error warning is sounded for 10 seconds every 10 minutes.
4) If the Power button is turned off and on, the error display disappears.
