50
- Organize and place hoses in the hole.
※ Caution: Be careful not to jam the hoses between
the wall and the washing machine.
11. Organize hoses
- Install the washing machine stick to the wall
surface.
10. Install the washing machine.
ⓛ Close the water supply valve
② Disassemble the water supply valve
③ Install the branching adapter (install
adapters accordingly on cold and hot
water taps)
④ Branch off the inlet hose.
13-2 Install the inlet hose - a kitchen sink or a shower
- Run a test operation to check if there is any
malfunction / leakage.
14. Test operation
- Connect plane washer (1EA) and spring washer
(1EA), and connect a regular nut (1EA) and
connect a fixing nut (1EA) last.
- Tighten the nuts with ø14 spanner.
※ Excessive fastening of the nut may cause damage to
the washing machine or the wall tile.
※ Fixing nut must be fastened to the end.
12. Fix the washing machine
① Close the water supply valve ② Disassemble the water supply valve
③ Install the branching adapter ④ Branch off the inlet hose.
※ Wrap the connection of the branching adapter and water supply valve with Teflon tape.
※ Check leakage after installation.
13-1. Install the inlet hose - Regular faucet
① Install the water tap connector on
the faucet (skip if it is a buried
faucet)
② Install the branching adapter.
③ Connect the inlet hose.
※ Check leakage after installation.
13-2 Install the inlet hose - a kitchen sink or a shower
Hot
water
For hot
water
For cold
water
Cold
water
- Inject chemical anchors into the fixed set anchors
- Insert cushion pads onto the fixed anchors
- Push the pads to the wall.
9. Inject chemical anchor and insert cushion pads
※ When injecting the chemical anchor, discard the first
10~15cm as the glue and hardener may not be mixed.
