Daewoo KQG-63N75S, Service Manual, Page: 10 / 25

9
4. Method to reduce the gap between the door seal and the oven front surface.
(1) To reduce gap located on part A
Loosen two screws on stopper hinge top, and then
push the door to contact the door seal to oven
front surface.
Tighten two screws.
(2) To reduce gap located on part B
Loosen two screws on stopper hinge under, and
then push the door to contact the door seal to
oven front surface.
Tighten two screws.
NOTE : A small gap may be acceptable if the microwave leakage does not exceed 4mW/cm 2 .
(1) Remove the gasket door from door plate.
(2) Remove the door seal as from door plate.
(3) Remove the door frame from door plate.
(4) Remove the stopper hinge top from door plate.
(5) Remove the spring and the hook.
(6) Remove the barrier screen outer from door frame.
(7) Reverse the above steps for reassembly.
9