Daewoo KORANDO, Service Manual, Page: 1220 / 1462

5D2-22 TRANSFER CASE (TOD)
Yes
No
B4
B5
Yes
No
B6
4.75-5.25Vdc
Yes
No
B7
0.3-0.9Vdc
4.6-4.9Vdc
Yes
No
4.6-4.9Vdc
0.3-0.9Vdc
Yes
No
Test Stage / Contents
Result
Stage Test Contents and Procedure
Specified Value
/Yes/No
Countermeasure
Check CAN communication line by diagnosis of E/G ECU.
1. Diagnose E/G ECU with SCANNER.
2. Does it display on fault code “27”?
Check power supply and signal output on throttle valve
position sensor (potentiometer) 1,2.
1. Diagnose E/G ECU with SCANNER.
- Fault codes : 104, 105, 108, 109, 119, 185
Does it display on above code ?
Check power supply (5V) of throttle valve position sensor.
1. Ignition “ON”
2. Measure voltage between pin 112(+) and 84(-) keeping
coupling connection status using multi - tester.
- Specified value
- Measured value is within specified range?
Check output signal from throttle position sensor 1 and 2.
1. Keep E/G idle status.
2. Measure output voltage between pin 87 (+) and 84 (-)
keeping E/G ECU coupling connection status using multi-
tester. (potentiometer 1)
- Specified value
min. acc. Pedal
max. acc. Pedal
- Measured value is within specified range?
3. Measure output voltage between pin 85 (+) and 84 (-)
keeping E/G ECU coupling connection status using multi-
tester. (potentiometer 2)
- Specified value
min. acc. Pedal
max. acc. Pedal
- Measured value is within specified range ? Replace TOD control
unit
Replace throttle body
actuator or check
cable
Perform B1, B2, B3
stages
Perform B5 stage
Perform B6 stage
Replace TOD control
unit or perform A1-
A5 stages
Perform B7 stage
Replace E/G ECU or
perform B1-2 stage
after checking cable.
Perform B7-3 stage
Replace throttle body
actuator or check
cable.