Daewoo KOD-135P9S, Service Manual

Page: 14 / 37

14
5. Method to reduce the gap between the door seal and the oven front surface.
(1) To reduce gap located on part ‘A’.
• Loosen the screw on stopper hinge top, and then
push the door to contact the door seal to oven front
surface.
• Tighten the screw.
(2) To reduce gap located on part ‘B’.
• Loosen two screws on stopper hinge under, and then
push the door to contact the door seal to oven front
surface.
• Tighten two screws.
NOTE : A small gap may be acceptable if the microwave leakage does not exceed 4mW/cm 2 .