14
5. Method to reduce the gap between the door seal and the oven front surface.
(1) To reduce gap located on part ‘A’.
• Loosen the screw on stopper hinge top, and then
push the door to contact the door seal to oven front
surface.
• Tighten the screw.
(2) To reduce gap located on part ‘B’.
• Loosen two screws on stopper hinge under, and then
push the door to contact the door seal to oven front
surface.
• Tighten two screws.
NOTE : A small gap may be acceptable if the microwave leakage does not exceed 4mW/cm
2
.
Summary of Contents for KOD-135P9A
Page 27: ...27 WIRING DIAGRAM...
Page 29: ...29 Measure Point MP2 MP1...
Page 31: ...31 2 PCB CIRCUIT DIAGRAM...
Page 35: ...35 4 PIZZA OVEN ASSEMBLY C00...
