Before operating your washer, install drain hose
properly.
First, connect the drain hose to the drain outlet at
the rear side of your washer, and then fasten it
tightly with the hose clamp.
Next, the other end of drain hose set as the below.
7
DRAIN HOSE SETTING
1
Connect the drain hose
to the drain outlet at the
rear side of the washing
machine, and fasten it
tightly with the clamp
supplied.
3
Hook the drain hose to the edge
of the tub, paying attention that
there are no bends or
constructions along the drain
hose.
Or, connect the drain hose to a
standpipe of a diameter greater
than that of the drain hose and
at a height of min. 70cm.
2
Attach the hose
guide included in
the accessory kit,
to guide the drain
hose over the tub
or standpipe.
4
Attach the hose guide included in the
accessory kit, to guide the drain hose over
the tub or standpipe.
PULL HOSE
THROUGH
FLEX HOSE
GUIDE
APART
55mm
Pump Model
1
In case that it goes over a
door sill. Don’t let the height
of the drain hose exceed
20cm from the ground.
.
2
In case of extending the
drain hose. Don’t let the
total length exceed 3m.
3
Be careful that the end of
the drain hose is not
immersed in water.
20cm
3m
Non-Pump Model
NOTES:
1. Let the highest point of the drain hose be more than 1m above the floor. If not so, the water in the washer could
be drained during operation.
2. Be sure that the height of the drain hose must be less than 1.4m above the floor, If not so, the wart in the washer
could not drain.
3. The hose guide MUST be fitted to the drain hose. The drain hose should not extend more than 55mm from the
end of the hose guide. This is to prevent ‘SYPHONING’. If necessary the drain hose can be trimmed to length.
MUST be
ventilated