Daewoo DMB-1822LH, User Manual

Page: 20 / 108

20
CONNECTING SIGNAL WIRES BETWEEN INDOOR UNITS AND OUTDOOR UNIT
The signal wires are used to inter-communicate indoor and outdoor’s signal, and attached to the indoor unit at first.
To install the signal wires to outdoor unit, follow the procedures below.
NOTE:
• Make sure the indoor & outdoor unit’s AC cord is not connected to AC power when connecting the signal
wires.
• When connecting wires, make sure they are fully inserted and minimum copper wire is exposed. If they are
not, shorting, overheating, no operation, etc. may occur.
• Be sure to comply with local codes on running a wire from the indoor to the outdoor unit.
• Must be careful to insert signal wire connectors where like color is like color.
1. Remove the screw holding on the connection
cover.
Remove the connection cover on the outdoor
unit to access the connection area.
3. Insert the indoor connector into the outdoor
connector from the PCB Board individually as
the following.
2. Route the indoor signal wire into the opening on
the outdoor unit and through the wire connector,
and insert the indoor connector into the outdoor
connector.
Connection
Cover
Indoor Unit A
White
Unit A
(White)
Unit B
(Red)
Outdoor PCB ASS'Y
White
Red
Red
Indoor Unit B
indoor unit A White – White
indoor unit B Red – Red