(2) Tum the handle of the engine to the "RUN" position.
(3) Pull the recoil starter handle out until you feel resistance. It will reset to its original position
automatically. The handle should be reset into its recoil device slowly to prolong the life of the life
of the engine starter.
(4) In cold climate, it is difficult to start the engine. To remedy this, pull the rubber plug out from the
rocker of the diesel engine and fill 2 ml of engine oil. Before starting, put the rubber plug back in
place. If you don't put the rubber plug back in place, rain, dust and other dirt can enter into the
diesel engine. It will cause the parts inside the diesel engine to wear quickly and lead to engine
failure.
2-4.2 Electric starting
The procedures for preparing to start eh engine are the same as the manual starting engine.
2-4.3 Battery
1. Insert key into ignition and put it in the "off' position.
2. Put the speed handle the "Run" position.
3. Tum the start switch clockwise to the "START" position; To set the silent type, first turn it clockwi-
se to the "RUN" (ON) position for 1-2 seconds. The electromagnetic iron will be triggered, now tum it
clockwise to the "START" position.
4. After the diesel engine is started, remove your hand from the switch handle; the switch will auto-
matically reset itself to the "ON" position.
5. If the engine is not starting after 10 sec-onds of cranking, wait about 15 seconds before trying it
again. If you crank to long, the voltage of the battery will drop. This can lead to improper ignition.
When the diesel engine is operating, let the ignition retain on the'
9
